by Dmitriy Nikitin | Aug 8, 2016 | Applications
The aluminum was marked with a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The part was surface etched, to create a highly contrasting mark. The part was marked at 35 inches per second using approximately 16 watts with a frequency of 35...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The aluminum was marked with a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The part was surface etched, to create a highly contrasting mark. The part was marked at 35 inches per second using approximately 16 watts with a frequency of 35...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
UID marking was accomplished with a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The small gear sample was marked on both sides. The side with the etched mark had a cycle time of 0.977 seconds. The side with the dark anneal mark had a...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked using a 20 Watt Q-Switched Fiber Laser with a 160 mm lens. The handles were marked inside of the requested area designated with a pink box. The parts were tested for contrast, but some of the plastics did not produce a contrasting mark. The...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Glass marking was done with a Synrad 48-2 25 watt CW CO2 laser with a FLA125 focal length lens. The glass was marked using a power of 25 watts at a speed of 25” per second, resulting in a cycle time of 0.52 seconds. The font was a simple stroke. The material provided...
