by Dmitriy Nikitin | Aug 8, 2016 | Applications
Material: Aluminum Power: 18 watts – Paint Removal 18 watt – Etching Method used: Engraving Frequency: 25 kHz – Paint Removal 80 kHz – Etching Depth:...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The part was surface marked to create brightly contrasting marks. The part was marked using various parameters, resulting in various cycle times and various darkness...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
This part was marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The 160mm focal length lens has a working distance of 176mm from lens to part. The part was surface annealed to create sharply contrasting marks. 16 watts of power...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The scissor blades were marked using a 20-watt q-switched ytterbium fiber laser, along with a 160mm focal length lens. The blades were marked with a dark surface mark. Each mark was made with the intention of keeping the cycle at or below 4 seconds. The blades were...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The carbide, oxide coated and stainless steel were marked with a surface etch, the stainless steel was marked with a dark mark as well. A light etch is produces the most contrast when marking on carbide. Marks were made at the heights of 0.075”, 0.1” and 0.15” The...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked with a 10 watt q-switched ytterbium fiber laser and 160 mm focal length lens. The 160mm focal length lens has a working distance of 176mm from lens to part. Two passes were needed to darken the steel with out causing too much warping of the...
