by Dmitriy Nikitin | Aug 8, 2016 | Applications
The samples were marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The samples were processed using approximately 18 watts of power, with a frequency of 35kHz, and at a speed of 10 inches per second, resulting in a cycle time...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The samples were marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The parts were ablated, to burn off the anodization without engraving into the aluminum, creating brightly contrasting marks. The parts were marked using the laser...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked with a 20-watt q-switched ytterbium fiber laser and 160 mm focal length lens. The parts were surface etched to create brightly contrasting marks.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked using a 20 Watt Pulsed Fiber Laser using a 160 mm lens. The carbide mills were etched using 7 watts of power in 2.31 seconds in the larger mill and 2.02 seconds in the smaller mill. Technology: Q-switched Fiber Laser Wattage: 20 Watt Wavelength:...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The scissor blades were marked using a 20 watt q-switched ytterbium fiber laser marking system, along with a 160mm focal length lens. The blades were marked with a dark surface mark. Each mark was made with the intention of keeping the cycle at or below 4 seconds. The...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
This part was marked using a 20Watt Fiber Laser Marking System using a 160 mm lens. A dark surface mark was put on the part. The marks placed on the large tap had a cycle time of 4.43 seconds.
