by Dmitriy Nikitin | Aug 8, 2016 | Applications
Sample was processed using a 20 watt Q-switched fiber laser through a 160mm F-theta lens.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
This part was marked using a 10-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The part was surface etched, to create contrasting marks. Material: Carbide Steel Method used: Surface Etch Depth: Surface Laser Type: Q-Switched Fiber Laser Focal...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Process Parameters: Large Parts – Dark Coating, Light Etch Material: Steel Power: 17 Watt Method used: Etching Frequency: 80 kHz Depth: Surface Speed: 3 inchsec Laser Type: Q-Switched Fiber Laser Focal Length Lens: 160mm (170mm WD) Cycle Time: 2.51 Seconds Process...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser cutting of this sawtooth was created using the SMB1200FL fiber laser cutting system.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Deep engraving was done on this red brick sample to show the capabilities of using CO2 lasers for engraving purposes. The depth and speed at which the process can be done simply depends on the power of the CO2 laser system.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20-watt q-switched ytterbium fiber laser with 160mm focal length lens. The small and medium drill bits were surface annealed at approximately 17 watts of power, at a speed of 4 inches per second, with a frequency of 75kHz, resulting in...
