by Dmitriy Nikitin | Aug 8, 2016 | Applications
The camshafts were marked with two types of marks. A dark mark as seen on the customer samples sent in with the application and a light etched mark. The light etch was done to get a contrasting mark with a shorter cycle time. The dark mark was done to duplicate the...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20-watt q-switched ytterbium fiber laser with a 160mm focal length lens. The parts marked according to customer request. The serial number S1811Y-RP was etched onto the material using 10 watts of power, with a frequency of 20kHz, at a speed...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The canisters were marked using the 20-watt q-switched ytterbium fiber laser, along with a 160 mm focal length lens. In order to get the marks along the outside diameter of the parts, each part was held in a fixture that allowed for manual rotation. Each part was...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Process Parameters: Material: Tool Steel Power: 18 Watt Method used: Surface Marking Frequency: 80 kHz Depth: Surface Speed: 4 inch/sec Laser Type: Q-Switched Fiber Laser Focal Length Lens: 160mm Cycle Time: 6.45 & 7.89 Seconds The parts were marked with a 20 Watt...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser markings on stainless steel
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked using a 20Watt Fiber Laser Marking System. Three types of marks were put on the parts. A bold darkened font (5.95 sec), a narrow darkened font (4.78 sec) and a lightly etched bold font (1.59 sec). The cycle times represent only the laser marking...
