by Dmitriy Nikitin | Aug 8, 2016 | Applications
The dark UID marking was done to duplicate the existing customer samples. To get the dark marks, multiple marking passes were needed. Three passes were needed total to the dark marks. The dark marks have a cycle time of 12.86 seconds and the light etch has a time of...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20-watt q-switched ytterbium fiber laser with a 160mm focal length lens. The parts marked according to customer request. The alphanumeric mark IRGCO was etched onto the material using 20 watts of power, with a frequency of 50kHz, and at a...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The canisters were marked using the 20-watt q-switched ytterbium fiber laser, along with a 160 mm focal length lens. In order to get the marks along the outside diameter of the parts, each part was held in a fixture that allowed for manual rotation. Each part was...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
UID marking was done using a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The parts were surface annealed, to create brightly contrasting marks. The parts were marked using approximately 18 watts of power, with a frequency of 35kHz, and at...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking on steel accomplished using a Fiber Laser
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The Laser marking on this steel was accomplished using a 20 Watt Fiber Laser
