by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The part was surface marked to create brightly contrasting marks. The part was marked using various parameters, resulting in various cycle times and various darkness...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
These plastic parts were marked using a 20 Watt Fiber Laser Marking System.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
This plastic gasket was marked using a 20 Watt Fiber Laser Marking System.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
This application was done with a low power system in the lab. The recommendation for this process, for the grey bulk molding compound, would be for a minimum of 100watt laser for projected cutting speeds of 1mm per second. Preferred system would be a 200watt laser...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The samples were marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The samples were processed using approximately 18 watts of power, with a frequency of 35kHz, and at a speed of 10 inches per second, resulting in a cycle time...
