by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser etching or marking a pagoda image/picture on a tile using a CO2 laser.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser engraving of this wooden block sample was done using a 100-watt CO2 laser through a 300mm lens. Sample Name: wood brick Working Distance: 220mm Material: wood Power: 60%-98% Method Used: Laser Engraving Frequency: 5 kHz Depth: >.001 Speed: 5-20 inches per...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The samples were marked using a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The carbide parts were surface etched, to create brightly contrasting light marks on the material. They were marked using approximately 11 watts of power, with a...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Process Parameters: Small Parts – No Coating, Anneal Material: Steel Power: 7 Watt Method used: Anneal Frequency: 35 kHz Depth: Surface Speed: 10 inchsec Laser Type: Q-Switched Fiber Laser Focal Length Lens: 160mm (170mm WD) Cycle Time: 0.45 Seconds All samples were...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking a cane image/picture on a tile using a CO2 laser.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
A UID data matrix with 3mil data cell size was laser marked on polished stainless steel stock. The mark produced had excellent contrast. The total mark time was 0.5 seconds. A 20 Watt CW Fiber laser was used to mark the dimensional data matrix; a single spot of 50...
