by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked using a 20-watt q-switched ytterbium fiber laser with 160 mm focal length lens. The samples were etched to create brightly contrasting marks. Material: Brass Power: 18 watts Method used: Etching Frequency: 20kHz Depth: Surface Speed: 25 inch/sec....
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The samples were sprayed with TherMark to create brightly contrasting marks. The parts were marked using approximately 18 watts of power, with a frequency of 80kHz,...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked with a 20 watt q-switched ytterbium fiber laser and 160 mm focal length lens. The parts were surface etched to create brightly contrasting marks.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
This steel tool was marked using a 20 Watt Fiber Laser Marking System
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The scissor blades were marked using a 20 watt q-switched ytterbium fiber laser, along with a 160mm focal length lens. The blades were marked with a dark surface mark. Each mark was made with the intention of keeping the cycle at or below 4 seconds. The blades were...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20Watt Fiber Laser Marking System using a 160 mm lens. A dark surface mark was put on the part.
