by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking on stainless steel accomplished using a 20 Watt Fiber Laser
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The samples were marked with a 10 watt q-switched ytterbium fiber laser with 160 mm focal length lens. They were surface etched, to create brightly contrasting marks. The parts were marked at a speed of 10 inches per second, using about 7 watts of power, with a...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The anodized aluminum key chains were marked with the 10 watt q-switched ytterbium fiber laser. All samples marked extremely well. The cycle time for marking the words Laser Photonics was 2.75 seconds. The parts were marked using 60% power. A 160 mm focal length lens...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
This brass part was marked using a 20 Watt Fiber Laser Marking System.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The carbide was marked with a surface etch. A light etch is produced the most contrast when marking on carbide. The cycle time for marking on the part was only 0.83 seconds. A bolder font was used to enhance the mark. The parts were marked with a 10-watt q-switched...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was laser marked with a 10-watt q-switched ytterbium fiber laser and a 160 mm focal length lens. The part was surface annealed using 3 watts of power, to create a contrasting mark. The part was marked at a speed of 15 inches per second with a frequency of 40...
