by Dmitriy Nikitin | Aug 8, 2016 | Applications
This part was marked with a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. This sample surface etched, creating marks of substantial depth on the surface of the material. The process for this Sample used a fiber laser at a setting of 10...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using the 20Watt Fiber Laser Marking System. A variety of marks were put on the part to widen the selection process while also demonstrating the fiber laser’s capabilities. Each barcode is numbered and the parameters have been recorded for each...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The dark UID marking was done to duplicate the existing customer samples. To get the dark marks, multiple marking passes were needed. Three passes were needed total to the dark marks. The dark marks have a cycle time of 12.86 seconds and the light etch has a time of...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20-watt q-switched ytterbium fiber laser with a 160mm focal length lens. The parts marked according to customer request. The alphanumeric mark IRGCO was etched onto the material using 20 watts of power, with a frequency of 50kHz, and at a...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The canisters were marked using the 20-watt q-switched ytterbium fiber laser, along with a 160 mm focal length lens. In order to get the marks along the outside diameter of the parts, each part was held in a fixture that allowed for manual rotation. Each part was...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
UID marking was done using a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The parts were surface annealed, to create brightly contrasting marks. The parts were marked using approximately 18 watts of power, with a frequency of 35kHz, and at...
