by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked with a 20-watt q-switched ytterbium fiber laser and a 160 mm focal length lens. The parts were surface etched to remove a layer of material and create a brightly contrasting mark. Process Parameters: Material: Brass Power: 6 Watts Method used:...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking of the aluminum casting was done using a 10Watt Fiber Laser Marking System. The two straight lines of text marked had a cycle time of 6.6 seconds. The part was marked using a 10-watt Fiber Laser Marking System.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Deep laser engraving of aluminum using a paint removal process. The powder-coated red aluminum part was laser marked using the i-Series Fiber Laser Kit with a 254mm lens. The part was engraved with a frequency of 50 kHz. The fastest method to remove the paint was to...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Purolator – Automotive Marking The Purolator samples were marked using the 10-watt Fiber Laser Marking System. The ends of the filters were cut off to compensate for the fixed workstations here in the Applications Lab. The ends were marked with the same text but...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Marking: Teflon Coated Steel – Clutchtex Clutch The part was marked using a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The metal oxide part was surface etched, to create brightly contrasting marks. The part was marked using...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The Laser marking on this brass part was accomplished using a 20 Watt Fiber Laser
