by Dmitriy Nikitin | Aug 8, 2016 | Applications
This part was marked using a 10Watt Fiber Laser Marking System. The parts were marked with a single line, narrow font as seen on the included samples, and a bold font to increase readability. The majority of parts were marked to do as little damage to the surface,...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part was marked using a 20Watt Fiber Laser System and a 160 mm focal length lens. The parts were marked per the spec attached to the application. The parts were marked with an arrow along with a Julian date code and plant code. The marking was aligned with the...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking on steel accomplished using a Fiber Laser
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked using a 10-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The parts were surface annealed, to remove the black paint and create contrasting marks. The parts were marked at a frequency of 20kHz and a speed of 10 inches per...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The brass gear marking had a cycle time 3.75 seconds. The part was marked using a 10 watt Fiber Laser Marking System.
