by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part marked had a cycle time of 6.6 seconds. This part was marked with a 10-watt Fiber Laser Marking System.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The part marked had a cycle time of 6.6 seconds. The part was marked using a 10 watt Fiber Laser Marking System.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking of the machined rubber/aluminum tube was accomplished using a 10 Watt Fiber Laser Marking System. The marking on the tube had a long cycle time of 8.91 seconds. The rubber was marked slower to produce a deeper mark. The parts were marked using a 10-watt...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking of the aluminum casting was done using a 10Watt Fiber Laser Marking System. The two straight lines of text marked had a cycle time of 6.6 seconds. The part was marked using a 10-watt Fiber Laser Marking System.
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The parts were marked using a 10-watt q-switched ytterbium fiber laser marking machine with a 160 mm focal length lens. The parts were surface etched, to create brightly contrasting marks. The codes read well in the lab, although the reader used in the lab is intended...
