by Dmitriy Nikitin | Aug 8, 2016 | Applications
UID marking was accomplished with a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The small gear sample was marked on both sides. The side with the etched mark had a cycle time of 0.977 seconds. The side with the dark anneal mark had a...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The plastic door handlers were marked using a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The working distance from the bottom of the lens housing to the painting surface was set at 180 mm (including 5 mm focal offset).
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The samples were marked with a 20 watt q-switched ytterbium fiber laser with 160 mm focal length lens. The paint film was ablated using 18 watts of power, frequency of 30 kHz. Due to the fact that the tallest marking would be in the 3 to 4 inch range, the 160-mm focal...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
The plastic door handlers and trunk finishers were marked with a 20-watt q-switched ytterbium fiber laser with a 160 mm focal length lens. The paint film was ablated using 18 watts of power, a frequency of 30 kHz. The paint film on the largest trunk finisher looked...
by Dmitriy Nikitin | Aug 8, 2016 | Applications
Laser marking on steel
